coachcampana
Well-Known Member
1/4 inch copper bar, and black micarta with a green g-10 liner and copper mosaic pins holding in the spacer.
O-1 tool steel blade.
I planned on putting a pocket clip on this when I was done but the clips haven't arrived in the mail yet. So I'll go without.
This is my 3rs friction folder. I tried to make the tang that sticks out I to a flat head screwdriver, but I can't say I did a great job of that.
They seem to keep getting better. But what lesson did I learn tonight? Sharpen the blade, THEN put it into the handle. I put some tin scratches into the copper while sharpening. Maybe I should be more careful when sharpening? Two lessons learned?!!
Annnnd it bugged me not adding the pocket clip. So here it is. Carbon fiber clip added today.
O-1 tool steel blade.
I planned on putting a pocket clip on this when I was done but the clips haven't arrived in the mail yet. So I'll go without.
This is my 3rs friction folder. I tried to make the tang that sticks out I to a flat head screwdriver, but I can't say I did a great job of that.
They seem to keep getting better. But what lesson did I learn tonight? Sharpen the blade, THEN put it into the handle. I put some tin scratches into the copper while sharpening. Maybe I should be more careful when sharpening? Two lessons learned?!!
Annnnd it bugged me not adding the pocket clip. So here it is. Carbon fiber clip added today.
Last edited: