Jason Wernli
Well-Known Member
Hey Guys, here is a new one to me. Last night I finished shaping 416SS bolsters for a new full tang hunter I am working on. I marked the pin locations and TRIED to drill them...no luck. Apparently I hardened them while cutting them out of the barstock.
I do not have a bandsaw (yet). I cut them with a cutoff wheel on a 4-1/2" angle grinder.
Has anyone else experienced this before?
Thanks,
- J
I do not have a bandsaw (yet). I cut them with a cutoff wheel on a 4-1/2" angle grinder.
Has anyone else experienced this before?
Thanks,
- J