rhinoknives
Well-Known Member
Here is one I just finished.
3/32" Stainless Raindrop pattern with stabilized Black Palm wood scales and red liners with S/S Loveless bolts.
Its 10" OAL with a 5 3/4" blade, its 0.035" at the heel edge and distal tapers to 0.016" at the edge tip.
I had Devin weld to 6" pieces of 440C on each end of the 3/32" AEB-L & 304 billet so I could get to small knives out of it. The other one is sold.
When I do a damascus knife I love the beauty of it and think that my logo interrupts it, so I put my www.rhinoknives.com in block on the spine. You can see the balance point.
Comments are welcome!
3/32" Stainless Raindrop pattern with stabilized Black Palm wood scales and red liners with S/S Loveless bolts.
Its 10" OAL with a 5 3/4" blade, its 0.035" at the heel edge and distal tapers to 0.016" at the edge tip.
I had Devin weld to 6" pieces of 440C on each end of the 3/32" AEB-L & 304 billet so I could get to small knives out of it. The other one is sold.
When I do a damascus knife I love the beauty of it and think that my logo interrupts it, so I put my www.rhinoknives.com in block on the spine. You can see the balance point.
Comments are welcome!
Last edited: