Search results

Huh? What mess? Nice Shop. Jerry

Chris, It looks like there might be some JB Weld between the pin and hole. Your pins and holes have to be absolutly clean before and during the peining process . If you are going to use JB Weld make sure that it doesn't squeeze out into the holes. Make sure that the pins aren't sloppy in the...

Dan That is a very nice peice of work, great damascus (feather is my personal favorite) and that guard is outstanding and the way everthing is put together, well it just flows! Jerry

Shane, I run my Norton surface grinder (Hydralic feed) and spindle motor with a static phase converter, I start the hydraulic motor first then the spindle, has worked fine for 5 years. That being said you can buy a VFD for just a bit more than a static converter. the trick is that it should be...

Hammerface, don't pound it on, heat it up and it will just slip on to the shaft. doesn't take a hole lot, (maybe 300 or 400 degrees). Jerry

Ok, just covering the bases, :D Jerry

Are you sure that your Rockwell tester is set up right. You need a diamond penetrator and unless it is the new digital type, you need the proper counter weights (at least on the one that I have that is the case) Also you can't properly test a razor blade on a normal rockwell tester, You will not...

I like it, very clean. Jerry