Do you only do the geometry or also tolerance blue prints for production? If there is a problem with geometry and or tolerances who is on the hook for scrap labor and material?
Also is the models included and if so what format?
I am in the process of Designing one of these which will be available through Tracy. It should be a couple of weeks so if you don't find one by then check with Tracy.
Thanks, Travis
Never a fun thing to have to do. But depending on what and how the tap broke there are a few things you can do. As you mentioned drilling it out is one way if it broke off nice and flat you can center punch it and drill it with a carbide drill(a HSS drill will not touch a HSS tap) but a good...
Instant gratification....:cursing: knife makers!:lol: They are being setup as we speak. As for the larger one I will make them .312 OD x .250 barrel x .500 OAL with a .062 wide head and a .062 wide x .03 deep slot. And they will go in right behind the smaller one. Will try for this week on the...
Ok, Here is what I have .250" OD X .187" Barrel diameter x .500" OAL with a .062 wide head and a .062 wide by .03 deep slot and a 6-32 thread in 416SS heat treated to 40HRC. If this sounds good to everyone let me know and I will get them moving.
Thanks, Travis
Yes I think they should be the same size also that is why i think they should be 6-32. I could easily make them .500" long, although to me that sounds a bit long, but i suppose its easier for the end user to remove stock then add it. And yes I would make them out of 416SS and harden them around...
Well I spoke to Tracy and he is willing to take a run of them if I can determine a popular size I can get them moving right away. The one I have drawn in the rendering I posted is .25 OD x .187 barrel diameter x .312 OAL with a .062 head height and a .062 wide x .03 deep slot and a 8-32...