Trade S-7 for L-6

Discussion in 'Trades Only' started by bubba-san, Dec 14, 2011.

  1. bubba-san

    bubba-san Well-Known Member

    I have a nice piece of S-7 that I want to trade for some good L-6 . The S-7 is 37" long x 5/8" round.

    I need a piece of L-6 ( not a substitute) about same length . would prefer flat steel 1' to 1-1/4" wide x 1/4" thick.

    I originally bought this for a sword but, I found out I can almost get about the same performance from the L-6

    and is a lot easier to HT . The S-7 is pretty expensive I paid almost 100$ for that piece . S-7 makes dandy

    hot work tools and anvils . Its just prohibitively high to work with . send me pm if your interested... Bubba
     
    Last edited: Dec 14, 2011
  2. HELLGAP

    HELLGAP Dealer - Purveyor

    Im sorry to say Ive got lots but im in canada. The shipping would be nuts on it. Kellyw
     
  3. bubba-san

    bubba-san Well-Known Member

    Too bad , mail could be expensive this piece weighs about 3.5 lb . Not sure what shipping would be . my zip is 63664 . May not be that much ? Depends if you use UPS , fedex or USPS or canadian post office . whats you postal code I can check from my end . Its some super steel extremely abrasive resistence and very tough......
     

Share This Page