New to the knife making world

Discussion in 'Introduction Page' started by jimbobwashere, Dec 14, 2016.

  1. jimbobwashere

    jimbobwashere New Member

    Hey everyone I am new to the world of knife making. I have been building a shop for the last year and I am finally almost able to get started. This is something that I have always wanted to do.

    About me...I am from Northern California. I have been in the US military for the last 10 years. I have a little background in metalworking and a lot of construction and building before I joined.

    it is great to be a part of this group and I look forward to learning all that I can.

    -Jimbob
     
  2. cnccutter

    cnccutter Well-Known Member

    Welcome Jim and thank you for your service.

    theres lots to learn about knife making and this is a great place to find a lot of the info. You should look around your area and I'd be willing to bet you have a knife maker(s) close to you. Buddy up to one of them it will help make the learning curve less challenging.

    most of all, have fun.

    Erik
     
  3. Justin Presson

    Justin Presson Well-Known Member

    Welcome Jim this is a great community and you will find lots of support here.

    Sent from my SM-G920P using Tapatalk
     
  4. BrandantR

    BrandantR Well-Known Member

    Welcome to the forum. There are a whole bunch of great folks here, willing to help out. It's a great place for sharing your struggles and successes.
     
  5. BladeFabricator

    BladeFabricator Active Member

    Welcome to the Knife Dogs Forum [​IMG]
     
  6. wall e

    wall e Well-Known Member

    Welcome to the forum, if you have a gun and knife show in your area it is a good possibility there are makers there. Find the one close to you that is selling quality stuff an try and learn all you can from them.
     
  7. toolsteelcalifornia

    toolsteelcalifornia Well-Known Member

    Welcome to the forum Jimbob! :)
     

Share This Page