Flat platen attachment parts

Discussion in 'Midwest Knifemaker Supply, LLC' started by Melw45, Jul 11, 2017.

  1. Melw45

    Melw45 New Member

    I was just about to cut the angle iron for the flat platen and noticed the plans don't have the length marked.
    It looks like it should be 8 inches long. Is this correct?
    Thanks!
    Mel
     
  2. ARCustomKnives

    ARCustomKnives Well-Known Member

    If possible, make it around 3/8" to 1/2" longer, so that you can put a 3/8" to 1/2" ledge to hold a pyroceram platen liner. 8" is a fairly typical length for the liner itself, so the substrate needs to be just a little bit longer.
     

Share This Page