Complimentary knife accessory with the right angle.

Fred Rowe

Well-Known Member
This set of 3 knives all have the same edge angle, which is 24 deg. inclusive. After looking for a commercial sharpener with the 24 deg angle and not finding one, I made up this matching counter accessory.
I used a set of carbide strips from an unused sharpener; gluing them together at the proper angle, using cyanoacrylic glue. The carbide unit was then cast in place using 2 part clear casting resin.
The project took a couple of hours to complete, but it might just save these knives from "caveman" sharpening technique.

DSC01454.JPG
 
Last edited:
Nice idea,
is it to late to put some kind of Guard on it to separate the Handle area from the sharpener? How about a piece of Antler, Drill a hole just to the left of the green line and glue in a 3" tall piece of stag.

Laurence

www.rhinoknives.com/
 
Back
Top