Bubble Jig belt machine sharpening with Kool Mist system.

Fred Rowe

Well-Known Member
Bethel Ridge Forge is doing all our sharpening and edge profiling, along with primary bevel grinding after heat treat on our new wet machine. This allows us to grind super thin primary bevels at set angles as well as sharpening at consistent repeatable angles.

The blades being sharpened in the video were done @ 15 dps our ERU sharpener being used to remove the burr, followed by a 1 degree micro bevel increase. The resulting edges should not be tested by shaving hair off your arm :)

[video=youtube_share;lCBUa4CAE4c]https://youtu.be/lCBUa4CAE4c[/video]


Happy to answer any questions, Fred

PS Our good friend Jeff Lawrence is sharpening his knives in this video.
 
Awesome work Fred, Bubble jig is the best. I got a chance to use my Kool mist setup with some AEB-l, never going back to dry grinding also keeps the dust in check.
 
Back
Top