Angryman Burke Fugitive

Discussion in 'Custom Knife Forum' started by Ltwtcmdr, Jun 1, 2010.

  1. Ltwtcmdr

    Ltwtcmdr Well-Known Member

    This is a collaboration between myself and Jim Burke. The design is his. I produced the parts. The blades were rough ground by CNC then re-ground and finished by hand by me.

    The design is a smaller version of his popular Fugitive custom model.
    On this paticular model the bevels are satin and the rest of the blade is tumbled.
    The Specs:
    3.5" 154cm blade hollow ground .150" thick double tempered and cryogenically quenched RC59
    Dual thumb studs
    .160" thick 6al-4v titanium frames
    Full length titanium backstrap-raised with traction grooves
    .050" thick bent titanium pocket clip-can be tip-up or tip-down (The clip in these pics is bent more than standard because I was trying out an idea )
    Screws and pivot pin are stainless steel
    CNC'ed Black G10 traction insert
    Anodized finish in either Tumbled Blue or Tumbled Silver
    [​IMG]
    [​IMG]
    [​IMG]
    [​IMG]
     
  2. Ironwolf

    Ironwolf The Knife Poet

    oh man,I really,really like that.
    Very nicely done!
    Stout,yet has a nice sleek profile.
     
  3. Denny Eller

    Denny Eller Well-Known Member

    Wow! Nice work, gentlemen.
     

Share This Page