Evenheat problem fixed

Had a problem with my oven over the weekend, and posted in another thread. As suggested by Tracy and Nathan, I contacted Evenheat, by Email, and Susan at Evenheat sent instructions on how to reprogram it, and all is well now. Just thought that I would pass along to others how great the service is from Evenheat.2thumbs

nice to hear. I should get a set of those. I'll send Susan an email.

BossDog said:

nice to hear. I should get a set of those. I'll send Susan an email.

Click to expand...

Trace, can you please post it when you get it?
- Thanks!

This is how to change the max temperature range for a SetPro controller:
Change STP Controller from °F to °C.
1) Turn Power off
2) Hold down Up Arrow Key, turn on the power, continue to hold down the Enter Key until “Edit” is in the display.
3) Release Key
4) Display should read User4
5) Press Enter
6) °F Displayed
7) Use the Arrow key to change from °F to °C
8) Press Enter
9) There will be a temperature displayed at this point
10) Use the UP arrow keys to choose maximum programmable temperature allowed.
Ceramic/ Porcelain/Pottery kilns use 2400F/ 1316C
Knife Ovens use 2200F/ 1204C
Glass Kilns use 1800F / 982C
11)Press the Enter Key
12)Complete


This is how to set the max temperature range on a Rampmaster controller:

Press OTHER - display=RSET
Enter 443 - display=NOTC
Press OTHER - until MAX is displayed
Press ENTER
The display will show the max temperature it is set to currently. Change to the correct temperature, 2200 degrees.
Press ENTER
IDLE/temp now shows on display.

Thanks, Brad!