It's been a long time since I finished a knife... This one has been sitting on my bench for over a year waiting to be finished. I finally had the time/wasn't recovering from surgery so it is now done! The handle is elk antler with a cocobolo spacer. Not sure what the blade is... It's either plow steel or 5160 from a leaf spring. Fittings are wrought iron. Comments/critique are very welcome! I know the second picture isn't all that great but it shows the temperline a bit better which is why I attached it. Not sure why the temperline ended up where it did... It should have been about half an inch back from the cutting edge for the whole length of the blade... oh well.