PDA

View Full Version : Spring loaded bevel grinding clamps.



Fred Rowe
11-13-2009, 06:19 PM
These spring assisted grinding clamps are forged from flat ground 01, hardened to 62HR.

They hold stock from 3/32" to 5/16" up to 2 inches wide.

OAL 5 3/4"

Each one is hand formed and adjusted after forging.

The clamps were coated with PBC to prevent decarb during heat treatment.

Using this clamp to hold your blades for bevel grinding allows for excellent control.
The long rounded end of the clamp not only helps with balance; its rounded end is made to position your thump, while grinding. This gives you very stable three point control.

You can see it in this video:
YouTube- Flat-grinder's Bubble Jig

I just made fifty of these clamps and have some extras.

They are priced @ 40.00 each plus 4.95 shipping conus.

I will ship anywhere with paypl; plus the added shipping cost.

Happy grinding, Fred


mailto:fred.rowe@bethelridgeforge.com (fred.rowe@bethelridgeforge.com)

http://www.bethelridgeforge.com/gallery/d/1583-1/bubblejigmachine_jpg+020.jpg