PDA

View Full Version : Porto Spans F/S Strider pivot pin tool



cuzzinkenn
10-15-2009, 06:57 PM
This is the "Porto Span", a tool I designed and machined for adjusting the pivot pin on a Strider knife. It is made from 316 series stainless steel and features both the spanner for the large Strider knives (NOT FOR THE PT MODEL) as well as an 1/8 hex wrench. The two halves screw together using a 1/4-28 thread with an "O" ring at the bottom of the thread to keep debris out. Dimensions are 3/8 thick x 5/8 wide x 1 & 3/8 long.
The price is $75.00 each and $5.00 S/H to USA and Canadian destinations only. I'm only accepting Pay Pal for payment.

To purchase send me a PM and I'll send my PP address.

Thanks for looking, Kenn

cuzzinkenn
10-24-2009, 03:11 PM
Hi Folks,
I still have several of these available.
Thank you, Kenn

cuzzinkenn
11-11-2009, 12:07 PM
Back to the top.
Thanks, Kenn

cuzzinkenn
11-28-2009, 04:14 PM
Back up top.
Thanks, Kenn

cuzzinkenn
12-08-2009, 12:20 PM
Bumpity bump,
Kenn

cuzzinkenn
12-31-2009, 08:23 PM
Alas, I still have some left...:)

cuzzinkenn
01-10-2010, 06:37 AM
There are still some available.
Thanks Folks,

cuzzinkenn
01-17-2010, 12:55 PM
I still have these available...:)

cuzzinkenn
01-25-2010, 07:51 AM
Bump!!!

cuzzinkenn
02-04-2010, 02:31 PM
Bump...:)

cuzzinkenn
02-12-2010, 09:46 AM
Bump
Thanks for looking Folks,

cuzzinkenn
02-27-2010, 10:34 AM
And another bump...:)

cuzzinkenn
03-07-2010, 07:21 AM
Back up to the top...

cuzzinkenn
04-04-2010, 08:51 AM
I only have 2 left folks.
Thanks for looking,