View Full Version : CPM M4 and sheep horn hunter
10-07-2009, 03:43 PM
This knife was made as a special request from 5/32 inch CPM M4, polished sheep horn with stainless bolsters and pins. It has a 4 inch flat ground blade and is hand polished. The next one is going to cost a lot more than this one did. The next stop will be Jim Small for some engraving and then Coop for some pictures.
10-07-2009, 03:44 PM
I would be proud to own- better yet to call it my own!
10-08-2009, 07:44 AM
Well done Harry! I like the spacer in there and the dovetail.
10-08-2009, 09:02 AM
Great looking knife. can't wait to see it finished.
11-06-2009, 01:24 PM
Here is the sheep horn hunter we posted a few weeks ago. It has now been dressed up a little by Jim Small.
Charlie used this hunter to clean and bone out a nine point white tail this past Saturday and it is none the worse for the wear. No it did not need to be re-sharpened. :D
11-06-2009, 02:45 PM
hello there Very nice work hello there
11-06-2009, 07:45 PM
Amazing knife sir.
11-07-2009, 05:02 PM
That is one sweet looking knife Harry. Looks like your usual excellent workmanship. Great job.
11-07-2009, 07:29 PM
Thanks for the comments guys. Charlie says this one is a keeper. We'll just have to see how long he can hold out.
11-08-2009, 07:32 AM
Beaytiful knives Harry
11-09-2009, 10:08 AM
Shore is one hell of a beauty.
Powered by vBulletin® Version 4.2.2 Copyright © 2014 vBulletin Solutions, Inc. All rights reserved.