View Full Version : Will this work?
02-10-2011, 04:44 AM
Could someone tell me if this will work,for my oven?
Thanks for the help.
02-10-2011, 07:50 AM
Sorry I haven't called you....I still have a croak rather than a voice...but I do feel a bit better today.
That kit appears like it will do the job for a kiln! A hint: Make sure that the seller offers all the documentation...especially the manual for the controller.
Most controllers have similar programming controls, with just enough difference that you will need a manual specific to the given controller. If you've not wired a SSR, it can be confusing at first, but once you understand that the SSR is nothing more than a "switch" for the Controller, that carries the current from the source (wall plug) to the applicance (oven) it's fairly intuitive.
The more documentation you can get for each component, the easier it will be on you.
02-10-2011, 08:30 AM
That's ok Ed,I know when you feel bad,you rather be left alone.
Thanks for that information
Hope you get to feeling better.
Powered by vBulletin® Version 4.2.2 Copyright © 2015 vBulletin Solutions, Inc. All rights reserved.