PDA

View Full Version : 3 NEW ONES



Andrew Takach
09-23-2009, 07:01 PM
here's a few i just finished. two were orders and the damascus huinter was just one i forged from a left over piece of a billet.

the mini-chete is just about 19'' o.a., and is forged from some W1 i got off the nj steel junkie.....thanks aldo:p

http://takachforge.com/images/101_0309.JPG

http://takachforge.com/images/101_0308.JPG

the hunter with the hammon if for a fella who wanted a knife made out of a file, the file was all surface ground prior to forging to prevent stress risors. the handle is desert iron wood burl, pins are nickle silver

http://takachforge.com/images/101_0304.JPG

the last one is a low layer forged hunter , some where around 50-60 layers of 15n20 and 1080. The handles are desert iron wood burl and it also is fully file worked, and has brass liners. i generally use nickle silver sheet when i put liners on like this cause i think brass almost is tacky...:barf: but i think they look good with the colors in the scales.

http://takachforge.com/images/101_0302.JPG

http://takachforge.com/images/101_0296.JPG

http://takachforge.com/images/101_0299.JPG

Lorien
09-23-2009, 07:17 PM
I'm lovin that machete!ride safe

Andrew Takach
09-23-2009, 07:20 PM
thanks lorien;)

ChipI.
09-23-2009, 07:50 PM
Andrew that is some great work . Great job on the filework

Andrew Takach
09-23-2009, 08:00 PM
thanks alot bro;)

brucegodlesky
09-23-2009, 08:39 PM
Andy, you been a busy boy!