PDA

View Full Version : Trying to figure out...



David66
09-12-2010, 12:34 PM
the best place for a new maker to post knife pictures. Here are three more, two without sheaths. Comments and constructive criticism welcome.

All three about 7.5"
O1 at about 61HRC.
Sheepsfoot flat ground the utility and camper high hollow ground.
I am a fan of Micarta, so you have natural, green and red linen.
pins are leftover # 10 bare copper from my shop build.

brunolundh
09-12-2010, 01:30 PM
Very nice, I especially like the forst one. How did you make the hole in the back?

/Bruno

Denny Eller
09-12-2010, 01:39 PM
Very nice work on both the knives and the sheath. All look like sturdy users.

whiteeugene
09-12-2010, 02:08 PM
Good looking knives I like you scale and pin colors.

David66
09-12-2010, 02:09 PM
Bruno: I didn't realize the thong hole doesn't show, I drilled 3 holes in a triangular pattern then connected the dots with a file and lots of sandpaper. If this style of knife seemed popular I would need to have it lazer or water cut, just too much labor for a hole.

Pieter
09-12-2010, 02:41 PM
Great looking knifes keep up the good work my man.