Custom made specialty wrench

[Calvin Robinson]

One of my brothers asked me to build him a special 18 mm wrench to get into a tight place on some equipment he services. This is 3/32" thick and 6" long,offset to get in there and save him about thirty minuets every time he must do this job.
I made it from Sandvik 14C28N and heat treated it to about 50 Rc. It should serve him well.

 

[Mark Behnke]

Pride in workmanship!

 

[Brad Lilly]

Sandvik 14C28N and heat treated it to about 50 Rc.

If he can't undo the fitting he can always cut it off. Nice job Calvin