Angryman Burke Fugitive

Ltwtcmdr

Well-Known Member
This is a collaboration between myself and Jim Burke. The design is his. I produced the parts. The blades were rough ground by CNC then re-ground and finished by hand by me.

The design is a smaller version of his popular Fugitive custom model.
On this paticular model the bevels are satin and the rest of the blade is tumbled.
The Specs:
3.5" 154cm blade hollow ground .150" thick double tempered and cryogenically quenched RC59
Dual thumb studs
.160" thick 6al-4v titanium frames
Full length titanium backstrap-raised with traction grooves
.050" thick bent titanium pocket clip-can be tip-up or tip-down (The clip in these pics is bent more than standard because I was trying out an idea )
Screws and pivot pin are stainless steel
CNC'ed Black G10 traction insert
Anodized finish in either Tumbled Blue or Tumbled Silver
new-fugitive-1.jpg

new-fugitive-2.jpg

new-fugitive-3.jpg

new-fugitive-5.jpg
 
Back
Top