gull wing
Well-Known Member
I'm trying something new, stainlesss steel for my liner locks instead of my usual titanium. I tested a pocket clip I made with .040" thick material and it turned out fine(1800 hardening and temper twice @ 750, two hrs).
My question is At what stage do you slice and bend the liner lock? Drill holes?
1. Before hardening? 2. After hardening? 3. Is there a problem with warping?
My question is At what stage do you slice and bend the liner lock? Drill holes?
1. Before hardening? 2. After hardening? 3. Is there a problem with warping?