Hello Forum Members-
I have been making knives for 9 months. They are getting better, and it is getting easier. But, this endeavor does have a steep learning curve. The fellows on Blade Forum have been very helpful. I am sure this group will be also. I have found that knifemakers are very willing to share their knowledge.
This blade is about 8.5" long, has a 4" blade, and was made from 3/16" 1095. The guard, pins, and tube are NS, and the handle is Imistag. I did all aspects including HT and the sheath. I sold it for $125, so that was rather encouraging. Comments welcomed.
Thanks for looking,
Milt
I have been making knives for 9 months. They are getting better, and it is getting easier. But, this endeavor does have a steep learning curve. The fellows on Blade Forum have been very helpful. I am sure this group will be also. I have found that knifemakers are very willing to share their knowledge.
This blade is about 8.5" long, has a 4" blade, and was made from 3/16" 1095. The guard, pins, and tube are NS, and the handle is Imistag. I did all aspects including HT and the sheath. I sold it for $125, so that was rather encouraging. Comments welcomed.
Thanks for looking,
Milt