Stew
Well-Known Member
Hi Guys,
I'm gathering bits to build myself a disc grinder.
Crazily, I can't source a disc to just put on the motor in the UK and importing from Tracey seems a bit excessive (and the bore size is wrong)
I have the mount for the motor sorted and someone has found me a supplier of Aluminium discs in any width, 1" thick.
Before I push the button on it, I was just wondering what anyone thought about using a 1/4" thick by 9" disc of Tufnol instead? I may be able to get some just for the cost of posting it over, which of course is nicer to my bank balance.
Waste of time?
All thoughts appreciated!
I'm gathering bits to build myself a disc grinder.
Crazily, I can't source a disc to just put on the motor in the UK and importing from Tracey seems a bit excessive (and the bore size is wrong)
I have the mount for the motor sorted and someone has found me a supplier of Aluminium discs in any width, 1" thick.
Before I push the button on it, I was just wondering what anyone thought about using a 1/4" thick by 9" disc of Tufnol instead? I may be able to get some just for the cost of posting it over, which of course is nicer to my bank balance.
Waste of time?
All thoughts appreciated!