Recent content by sparrow

Thank you. I will do that, hope it will work.. anything but the VFD gone bad :sad:

So I'm grinding some micarta scales today on my homemade treadmill motor grinder, around half the speed. And all of a sudden, It started going full speed, sparking from the rear end of the motor.. VFD controls are not working, I can't slow it down, I can't stop it on the stop button. There is...

Thank you @KenH, It's square inside. I wanted to put round tube beneath the clamp, but could not find the matching diameters.. this is very low cost build, so I worked with materials that where available to me at the time. That said, the connection is rock solid, there is no way that I can turn...

Thank you @Don Robinson.. :biggrin: The roof was the only place where i could shoot it properly. My shop is miniature

I finished this few days ago. It took pretty long to make but it's finally done :5:. 1,75 HP treadmill motor with variable speed control. Thanks for watching Vladimir Woof!

Nice blade on the red one

Thank you

Thanks dawgs :) this is my first stacked leather handle and i really like how that stuff looks and feels

I finished this one recently for a friend steel 5160, handle stacked leather, guard and butt cap are brass OAL 22 cm, blade length 10,5 cm, 3 mm thick Thanks for watching

Fine looking knife

Bump

Thank you gentlemen :) .. glad you like it

This one means buisness Marvin :14:

Hi all, i would like to sell this knife Steel is O2, handle is wallnut and brass OAL 13,2 inches, blade lenght 8 inches price is 420$ Thanks for watching

Thanks!