Recent content by SIXFOOTER

Thank You very much!

How did you get the profile on the cutting side?

Hmmm, I might be into that. My Microtek bit the dust and it was the only good auto I had.

Thats what the steel is for next to the anvil, soon as I get the welder fixed.

Well, despite the problems with my welder, I made a little progress today. Got my anvil setup, got it and a couple other new toys a while back but other projects have been in the way, that new fence behind the anvil for one. Anvil is a 112# unit from NC tool, seems to be the answer I been...

Hey Bob; Been a while since it was used last, a bit of rust on the wire, but not much. There is a lube pad on the wire where it goes in the feeder. Didn't see any alignment problems, the wire is bunching up between the drive wheel and the feed port for the hose. Bad liner maybe? Can I buy...

I have a Daytona Mig 160, been a good machine. However today, it keeps jamming the wire at the drive point where the wire goes in the hose. I disassembled the hose, cleaned, reassembled, put on a new tip and it keeps jamming. I can run several feet with no problem until I strike an arc. Ground...

Howdy; Texas guy transplanted in South Florida. Made my first knife some 20 yrs ago, just got started again recently and have not made much progress other than to build a KMG clone, gather up a bunch of material and tools I didn't have before and learn some Blacksmithing. On to the blade making...