Recent content by c.mcneil

Thanks for the comments guys, I like cheap solutions (knifemaking is spensive) I originally used the idea for my reloading bench, so i could switch out my single stage press for my progressive. It is surprisingly sturdy setup. I spent two hours last night using the disc grinder both ways and I...

Well I finally finished my shop and I thought I would share my solution for mounting my disc grinder. Vertical and horizonal, its cheap and works great. Just some plywood and cut a 30 degree bevel and a handful of screws. Thought I would share, thanks Chris

Its amazing what a little spit and polish can bring some life back into a machine. This was my green single speed bader, before I put a little work into it. The difference of grinding with a variable speed vs. single speed is night and day. What else can i say. I just had to post a few photos

Hey I wanted to get i a quick introduction for my fellow knifedog forum members. I met Tracy at Blade last year and have spoke with several members at various knife shows, and past blade shows. I have been making mainly stock removal knives for the last year or so after getting my shop set up...

Hello I am in the process of wiring my kbac 27 and 2hp leeson motor, and i had a question about the SO cord going from the VFD to the motor. I used 14-3 SO 600v for the power supply cable. Does it need to be shielded, and should i use 14-4 SO cable or 16-4 SO cable, and would it be better to...