K
KB1SYV
Guest
Hey Guy's,
I have to make use of drill bit's since I don't have a height gauge. If I have a 1/8" piece of metal how would I mark the two lines(one for each side)? It measured 4/32" and I took 2/32" to be the halfway point. I then used a 1/16" bit to mark a line on each side. Well that didn't come out right. Where is my thinking going astray?
Thanks Everyone.
Jeff
I have to make use of drill bit's since I don't have a height gauge. If I have a 1/8" piece of metal how would I mark the two lines(one for each side)? It measured 4/32" and I took 2/32" to be the halfway point. I then used a 1/16" bit to mark a line on each side. Well that didn't come out right. Where is my thinking going astray?
Thanks Everyone.
Jeff