3 Finger Skinner

maxcutter03

Well-Known Member
Here is a little 3 finger that I made for a customer in Florida. If you looked at the tutorial forum, its the same knife.

OAL 6.25"
Hollow grind
Blade CPM 154 CM
Scales Arizona desert ironwood burl
Bolsters 416 SS
Bolts Corby 316
Tapered tang

Your comments are all welcome!!!
IMG_3491.jpg

IMG_3494.jpg

IMG_3489.jpg

IMG_3486.jpg


All comments welcome....
 
Last edited:
Hey boys got a noob question for ya. Why is it called a "3 finger" skinner? cheers in advance.
 
Great looking knife and sheath with excellent fit & finish on both. Enjoyed your tutorial too. I hope you post some more of your next knives.
 
Hey boys got a noob question for ya. Why is it called a "3 finger" skinner? cheers in advance.

Because it's short. A person with an average or large hand will only get three fingers wrapped around the handle, and their pinky will wrap around the butt. Little knives like that are very handy in tight spaces and this is a really fine example. 2thumbs
 
Back
Top