Neck Knife

J. Hoover

KNIFE MAKER
This one is SOLD, thanks

Reducing this one, 65.00 will get it to your door if you live in the USA or Canada.
I've been wanting to make a neck knife for while now so I finally sat down a few days ago and sketched out several designs then made a template so I could make more if anyone was interested. Anyhow this is the one I decided to do first. Here are the specs:

Steel- O1 X 1/8 tool steel
HT- In house and triple tempered to 58-59 rc
AOL- 5 1/2 inches
Grind- Flat with serrations on spine
Blade- 2 inches tip to plunge
Handle- 3 inches
Scales- Maroon G10
Hardware- 1/8th 416 stainless pins
Sheath- Kydex , chain is included but not pictured
Asking 85.00 shipped in the USA or Canada. International orders welcome but buyer pays the additional shipping cost
Paypal or USPS M/O preferred
Comments or questions welcome
Thanks for looking

003-12.jpg


004-10.jpg


005-13.jpg
 
Last edited:
Thanks for the kind words, this is a slick little cutter. Small enough that it can be worn under a loose fitting t-shirt with out anyone noticing, but ready to do some serious work if needed.
 
Back
Top