Eric Ochs
Well-Known Member
Here is one of my new designs released for the Oregon Knife Collectors Show last weekend.
This model is the Orca Pirate Knife
Blade: 5/32" Wide
CPM S30V with Paul Bos Heat Treat
4-9/16" blade edge
Primary bevels are flat ground and hand rubbed finish
Back edge with hollow ground yelman 2-1/8" (Not sharp on this one)
Handle with Full Tang, finger groove & thumb notch:
Carbon Fiber with liner - both from USA Knifemaker
Mosaic pins are stainless and brass
Two Stainless pins at integral guard with thong tube to match
Here is another one which has a satin finish blade and black and green G10 handle incorporating two copper & nickel silver mosaic pin, two copper pins and a copper thong tub with leather sheath in burgundy.
This model is the Orca Pirate Knife
Blade: 5/32" Wide
CPM S30V with Paul Bos Heat Treat
4-9/16" blade edge
Primary bevels are flat ground and hand rubbed finish
Back edge with hollow ground yelman 2-1/8" (Not sharp on this one)
Handle with Full Tang, finger groove & thumb notch:
Carbon Fiber with liner - both from USA Knifemaker
Mosaic pins are stainless and brass
Two Stainless pins at integral guard with thong tube to match
Here is another one which has a satin finish blade and black and green G10 handle incorporating two copper & nickel silver mosaic pin, two copper pins and a copper thong tub with leather sheath in burgundy.
Last edited: