Where to etch logo on this knife?

J

J.McDonald Knives

Guest
Well I have room on the ricasso but was wondering where it would be better to etch my logo. Where do yall think I should put my logo? Yes I still have a bit more finish work to do on it but figured I would post up while I'm putting the satin finish on it. Also what do yall think I could sell this one for? It will have a kydex sheath and blade thickness is 3/16" and made from 1080.

attachment.php
 

Attachments

  • DSC01723.jpg
    DSC01723.jpg
    102 KB · Views: 120
It looks pretty nice J. I think the handle will take abit more gloss with some elbow grease and fine grit paper.
You have room on the ricasso I think for your logo.
Overall nice design. If the heat treat is right this will be a heck of a hunter.
 
JR. Who made the knife.:duh:HEHEHEHE!!! Done good me like.2thumbs2thumbs
Thanks dad. I'm working on finishing it and finishing up the bowfishing knives. I got one assembled and just need to finish up the handle and then hand sand the blade. Now I know how much work yall put into the leather stacked handles, slotting each disk gets to be a little tedious.
 
Back
Top