Lathe Dagger

Sam Salvati

Well-Known Member
I had mentioned I was learning to use a lathe. I decided to make a dagger and turn the handle from brass/bronze and here it is. It certainly isn't precision or anything, just turned by eye having a bit of fun on the lathe. The blade is 5160, with a chiseled in fuller, 1/2 double edge, fileworked spine. I turned the handle and pommel, but made the guard the old fashioned way. I was going to make the pommel a nut and thread it on but ended up making it a peened assembly. I ground all the cutters myself for all the different cuts, but mainly used a thin straight cut and a right cut. Also tried knurling the front and end of the handle.

l_e1a3aac0b097443bb3482e13e632cc36.jpg


l_c4ff9b1b2ddb4a1099237e899a1a6ab8.jpg


l_8e3775290ead46dfa22f1e029f8cf7ff.jpg


l_84237597fd6148e6afad479aec5d6668.jpg


l_9b5053ca7ecc48b1a8abe8e80e6a9531.jpg


And also, A VIDEO!

[ame="http://www.youtube.com/watch?v=DKl9EuI-xOc"]YouTube- new dagger[/ame]
 
That is awesome! 2thumbs At what length does a dagger become a sword? ;)
 
Back
Top