Bird& Trout

J. Hoover

KNIFE MAKER
Here is one I recently completed .
Steel- 5/32 X 1 D2 Tool Steel
AOL- 9 1/8 inches
Clip point Blade- 4 9/16 to front of guard
Handle- 4 1/2 inches to front of guard
Scales- Stabilized Black Ash Burl from Larry, Shaughnessy on the forum
Hardware- Brass
RH sheath was handsewn and fitted to this knife by the maker using 7 ounce vegetable tanned leather.
Comments, questions or critiques welcome

012.jpg


003-2.jpg


010-2.jpg


007-3.jpg


009-2.jpg


011-1.jpg
 
Nice. Beautiful handle, nice sheath.

But isn't this knife a little bit bigger than the traditional "bird & trout"?

Kind regards,

Jos
 
Yes it is pushing the limit I would think in length, however it is slim and light and very usable and made to a customers request.
 
Back
Top