Finally getting back to it

Travis Fry

Well-Known Member
Here is one I just finished for a guy I work with. I've been really busy and not been in the shop much since last Fall, but things are starting to pick up a bit.

OAL: about 7.5"
Blade: about 3" CPM 154 CM
Bolsters: 416SS
Hidden pins
Scales: Stabilized Bigtooth Maple burl from Rob at Bad Dogs Burl Source.

This is one of my favorite designs, and I keep thinking the bolsters should be engraved. This one is going to be used hard for skinning hogs and deer though, so this is probably the nicest it will ever look.

Maple knife.jpg
 
Great traditional looking design. How could you get any better for a hog and deer knife.
 
Back
Top