franklin
Well-Known Member
I dont know if this will help anyone, but lately ive been quenching my 1095 then straight to a set of stainless plates i made. (2 inch wide x 12 inch long x 1/2 thick) One side i surface ground, has soon as it comes out of the quench i put it inbatween the plates, Then i have 3 wood style clamps that i tighten up and let sit for a couple of min.
From there i remove from the plates and clean up, then temper. Since i started this NO warped or bent blades, give it a try, hope this helps. i will post a pic of the plates later.
From there i remove from the plates and clean up, then temper. Since i started this NO warped or bent blades, give it a try, hope this helps. i will post a pic of the plates later.
Last edited: