Lerch
Well-Known Member
Hi all
I am wanting to start adding thumb serrations to my knives. I did one once before with a drill press and a small tungsten carbide bit that was intended for a dremel tool, it was a pain!!
I dont have a mill so i was wondering if any one had any ideas on how to make them. I want them to ideally be about a 1/8" deep and about four or five rounded serrations spread over a 1" or a little more area.
thanks
steve
I am wanting to start adding thumb serrations to my knives. I did one once before with a drill press and a small tungsten carbide bit that was intended for a dremel tool, it was a pain!!
I dont have a mill so i was wondering if any one had any ideas on how to make them. I want them to ideally be about a 1/8" deep and about four or five rounded serrations spread over a 1" or a little more area.
thanks
steve