Eric Ochs
Well-Known Member
I am calling this the Gyrfalcon and this is my first one that will go out next week. But first this goes to the OKCA show in Eugene with me. In the interest of full disclosure I did make a prototype last summer that a few of you may have seen, but did not want to put it out there as my shop was really not ready to deal with making folders. However, I have worked hard to remedy that situation.
Also, I would like to thank my friend Gus Cecchini for his friendly advice and patience as well as Michael Burch who has also been very helpful from time to time.
Specs:
4" blade edge made from S30V at .165 thick with Paul Bos Heat Treat to +/-59 RC.
0.080 TI liner frame with hammered nickel-silver bolsters and Marble Carbon Fiber. Carbidized lock face. Oh, it is a Southpaw too.
Thanks for looking,
Eric
Also, I would like to thank my friend Gus Cecchini for his friendly advice and patience as well as Michael Burch who has also been very helpful from time to time.
Specs:
4" blade edge made from S30V at .165 thick with Paul Bos Heat Treat to +/-59 RC.
0.080 TI liner frame with hammered nickel-silver bolsters and Marble Carbon Fiber. Carbidized lock face. Oh, it is a Southpaw too.
Thanks for looking,
Eric