genewiseman
Active Member
I have just ordered a oven and should get it fed-ex any day now. I am wanting to start using D-2 for my folder blades and springs. Up until now, I have been using 1095 and a torch for heat treating. I need instruction on how to use the foil that you put on the blades while in the oven and information on plate quenching as I have heard that will keep my blades from warping.
Are there any instructional books or videos on basic heat treating procedures for knife makers? Any information would be greatly appreciated.
Thanks a lot,
Gene
Are there any instructional books or videos on basic heat treating procedures for knife makers? Any information would be greatly appreciated.
Thanks a lot,
Gene