Finally...one worthy of heat treating

Eric Poris

Gold Membership
Hey All,
Just wanted to get some feedback from everyone. I have been busy in the shop learning how to use my NWG and here is what I have to show for it.

View attachment 17140View attachment 17142IMG_0187.jpg

Started with a .25" thick bar of CPM154 and got it down to about 3/16" thick. The edge isn't perfectly flush with the wheel, but that is going to be ground down to the cutting edge so I don't care at this point. Also, I'm going to be grinding it a bit more after heat treat so a few flaws will be corrected once that is done.
9.5" OAL
4.25" blade
Feels very good in the hand and deceivingly light weight.
I will be attaching some MCAM G10 for the scales. More pics to come after heat treat.
All comments are welcome.
Thanks for looking!
Woof!
-Eric

IMG_0457.jpgIMG_0455.jpg
 
Last edited:
Looks dang good from my end of the world wide web. Look forward to seeing your progress.
 
Agree with the top 2 comments nothing wrong with that can't wait to see it completed.
 
Back
Top