I'm working on my first knife, a kit from Jantz.
The knife blank is pre-drilled with 1/8" holes. Rather than using the pins that came with the kit, I want to use 1/8" mosaic pins (that I also purchased from jantz). The probem is they won't fit. I don't have a micrometer to check the pin thickness (diameter).
Idiot question here:
Should I use a reemer to bore out the holes in the handle?
or, another drill bit?
If so, what size should I use (of either one)?
Thanks!
The knife blank is pre-drilled with 1/8" holes. Rather than using the pins that came with the kit, I want to use 1/8" mosaic pins (that I also purchased from jantz). The probem is they won't fit. I don't have a micrometer to check the pin thickness (diameter).
Idiot question here:
Should I use a reemer to bore out the holes in the handle?
or, another drill bit?
If so, what size should I use (of either one)?
Thanks!