My first D2 blade

Screwy Squirrel

Well-Known Member
This is my first attempt at a D2 blade started small, this is a 2 inch neck knife. Now I need to get finished for heat treating, Wondering who I should use ? Maybe BOS.
 

Attachments

  • IMG_0506.jpg
    IMG_0506.jpg
    87.1 KB · Views: 19
  • IMG_0508.jpg
    IMG_0508.jpg
    85.3 KB · Views: 17
Last edited:
Cooooll!!!!:57: But Lil' Mikey, I think you should drill some pin holes for the handle before you send it out. HEHEHEHEHE!!!
 
I think you should drill some pin holes for the handle before you send it out. HEHEHEHEHE!!! Thanks George that was part of the finishing I mentioned.
 
You should think about grinding out a few more first . If you send it to any of the bigger commercial heat treaters , you will pay a minimum PLUS additional costs . At least $50 . Try one of the Knife supply houses , some offer heat treating a single blade for much less .
 
Got in touch with Texas Knifemakers supply they are going to do the heat treat and cryo for $18.50 with shipping. thanks guys !
 
Back
Top